Difference between revisions of "I/O sniffing"

From Linuxintro
imported>ThorstenStaerk
imported>ThorstenStaerk
Line 4: Line 4:
 
  initiator BLA writes block 1234 to device 9876  
 
  initiator BLA writes block 1234 to device 9876  
 
  block 4711 arrives from device 0815
 
  block 4711 arrives from device 0815
 +
 +
It pays to have a good understanding about [[Bandwidth, latency and throughput]], [[block sizes]], caches, buffers, IOPS, async I/O vs sync I/O and buffered I/O vs direct I/O.
  
 
You can do I/O sniffing using the command blktrace. blktrace will show you every request that goes to the disk.
 
You can do I/O sniffing using the command blktrace. blktrace will show you every request that goes to the disk.

Revision as of 14:01, 26 December 2013

Sometimes, for example when troubleshooting performance problems you need to understand how your system interacts with its hard disks. You may have used ioMeter to measure your disks' speed and ioStat and sar to gather statistics. However sometimes you need to drill down deeper into the analysis, you need to understand what happens on the block level. I call this I/O sniffing. The goal is to observe packets like this:

initiator XYZ requests block 4711 from device 0815
initiator BLA writes block 1234 to device 9876 
block 4711 arrives from device 0815

It pays to have a good understanding about Bandwidth, latency and throughput, block sizes, caches, buffers, IOPS, async I/O vs sync I/O and buffered I/O vs direct I/O.

You can do I/O sniffing using the command blktrace. blktrace will show you every request that goes to the disk.

Example:

# blktrace -d /dev/sdg -o - | blkparse -i - 
[...]
  8,96   7      106     0.373952974 11364  D   W 0 + 8 [kworker/7:2]
  8,96   7      107     0.374456639    47  C   W 0 + 8 [0]


The RWBS(D) field can be a combination of

R : Read
W : Write
D : Block discard
B : Barrier operation
S : Synchronous operations

See also