Route

From Linuxintro
Revision as of 01:42, 14 April 2009 by imported>ThorstenStaerk

The command route lets you view and modify your computer's network routing table. You can use it when troubleshooting network problems or when you have more than one network card.

If you just call route, you get a list of routing rules, like this:

# route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.0.0     *               255.255.255.0   U     0      0        0 eth1
link-local      *               255.255.0.0     U     0      0        0 eth1
loopback        *               255.0.0.0       U     0      0        0 lo
default         192.168.0.1     0.0.0.0         UG    0      0        0 eth1

The first blue line means: If there is any IP package for an IP address 192.168.0.*, just send it over network device eth1. The second blue line means: Every IP package that has not been handled yet, send over network device eth1 to the default gateway 192.168.0.1.

Removing a rule

# route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        0 eth0
192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        0 eth1
169.254.0.0     0.0.0.0         255.255.0.0     U     0      0        0 eth1
127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0 lo
0.0.0.0         192.168.0.1     0.0.0.0         UG    0      0        0 eth1
# route delete -net 192.168.0.0 netmask 255.255.255.0 eth0
# route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        0 eth1
169.254.0.0     0.0.0.0         255.255.0.0     U     0      0        0 eth1
127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0 lo
0.0.0.0         192.168.0.1     0.0.0.0         UG    0      0        0 eth1

See also