Difference between revisions of "Ethtool"
From Linuxintro
imported>ThorstenStaerk (New page: ethtool allows you to check if a network cable is correctly plugged into an ethernet port: # ethtool ''eth0'' Settings for ''eth0'': Supported ports: [ MII ] Supported li...) |
imported>ThorstenStaerk |
||
| Line 22: | Line 22: | ||
''' Link detected: yes''' | ''' Link detected: yes''' | ||
This shows you that a physical connection to the network port eth0 has been established. A basic connection to the network switch or computer on the other end of the cable could be established. | This shows you that a physical connection to the network port eth0 has been established. A basic connection to the network switch or computer on the other end of the cable could be established. | ||
| + | |||
| + | = See also = | ||
| + | * [http://man-wiki.net/index.php/8:ethtool ethtool's man page] | ||
Revision as of 13:50, 6 April 2009
ethtool allows you to check if a network cable is correctly plugged into an ethernet port:
# ethtool eth0
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Current message level: 0x000000ff (255)
Link detected: yes
This shows you that a physical connection to the network port eth0 has been established. A basic connection to the network switch or computer on the other end of the cable could be established.
